When the air pressure in the air storage cylinder does not reach the pressure set by the pressure regulating valve, the gas entering the pressure regulating valve from the air storage cylinder cannot open the pressure regulating valve valve; when the air pressure in the air storage cylinder reaches the pressure set by the pressure regulating valve , The gas that enters the pressure regulating valve from the gas storage cylinder opens the pressure regulating valve valve, enters the air passage in the air pump communicating with the pressure regulating valve, and controls the air inlet of the air pump to be normally open through the air passage, so that the air pump runs at no load
To achieve the purpose of reducing power loss and protecting the air pump. When the air pressure in the air storage cylinder is lower than the pressure set by the pressure regulating valve due to loss, the valve in the pressure regulating valve is returned by the return spring to disconnect the control air circuit of the air pump, and the air pump starts pumping again. This is the working principle of the aerator air pump. The aluminum alloy air knife will also be electroplated. , To isolate the vibration. The engine of the aerator drives the crankshaft of the air pump through two V-belts, thereby driving the piston to pump air, and the generated gas is introduced into the air reservoir through the air guide tube. The air knife performance of the vortex air pump is very outstanding. Use in highly corrosive environments.
When selecting an air pump, consider the flat washers and spring washers that must be used during installation to tighten the screws. It is essential to choose rubber buffer rubber to bear the weight of the vortex air pump, especially the high-power vortex air pump. So, how much do you know about the aerator air pump, let’s take a look at it together.Reasonable use of aquatic aerators can not only prevent and reduce the floating heads farm aerators of fish and shrimps, but also improve water quality, strengthen the material circulation of the pond water body, reduce or eliminate harmful substances, and promote the reproduction of plankton.
The silencer is installed at the end of the air inlet or outlet pipe. On the other hand, the gas storage tube introduces the gas in the gas storage tube into the pressure regulating valve fixed on the gas pump through a gas tube, thereby controlling the air pressure in the gas storage tube.. Thanks to friends for their support and encouragement, we will sum up our experience, keep making progress, and provide better aquatic aerators to meet the needs of users. The air knife is made of aluminum alloy and stainless steel. When the compressed air of the air pump enters the air knife, he will use the airflow to blow it out at a very high speed. Aquatic product aerator tells that if you have requirements for noise, you can install a silencer on the air pump to reduce the noise. There is no wear inside the air knife, and the gasket inside is also made of stainless steel. The air inlet and outlet pipes of the vortex air pump should be connected by hoses
Tags: farm aerators
mainsfeeder