iNGENET - La comunidad de la ingeniería mexicana

At present, domestic neural networks and expert systems both use frequency-based signal characteristics. The different frequencies are shifted and stretched, and the frequency band information can be selected selectively, effectively reducing noise interference, and avoiding the amount of information that is redundant and unfocused. For example, wavelet analysis is to decompose signals through a series […]

The torque is transmitted by the teeth of the internal and external teeth. Fixed rigid coupling It is composed of two semi-circular pig iron clamp shells, which are clamped with anchor screws. Universal coupling, suitable for medium speed It is composed of 2 fork-shaped terminals and cross heads. Anchor screw connection: special anchor screw connection, […]

Drum tooth is made of external teeth into a curved surface. If the drum-shaped gear coupling is installed too large, it will very likely cause the head clearance of the drum-shaped gear coupling to disappear. The gear coupling is composed of internal gear with the same number of teeth and a boss half coupling with […]

Maintenance is required so that the coupling can be kept in good condition when China Drive Shaft Suppliers it is operating. The direction of rotation and the magnitude of the torque are not changed during the movement. Alignment: For good alignment, choose a rigid coupling, and choose a flexible coupling when compensation is needed; We also […]

When the universal joint shaft is used, it will sometimes produce a certain vibration due to shaking. When the universal joint is bent and the shaft tube is recessed and the drive shaft is assembled, the mark does not tend to connect the shaft and the shaft tube fork of the universal joint and spline […]

Fixed coupling: the centerline of the two shafts to be connected is required to be strictly aligned; Removable coupling: allow a certain installation error for the two shafts. In fact, in the working process, the two shafts are always in a connected state called a coupling. For the two shafts connected by the coupling, due […]

In addition, a grease nipple with a protective shell is dried on the top of the rolling bearing for convenient filling of grease. Then, the slab heated to above 1300 degrees is extruded and deformed, and the thin and thick steel plates required for the middle rolling process are output.05mm-0. Because of the hazards of […]

When a car is damaged or malfunctions, it is very important to repair it. Therefore, when your vehicle is damaged and cannot work normally, car repair is essential. But first, you must determine the problems with your car, and then you should try to fix these problems by repairing the car. Many people spend a […]