When the couplet is found to be positive, the principle of similar triangle can be used, and the impact of the facade clearance can be used to take into account the impact of the facade.03mm; The facial clearance error is not greater than 0. If the device is found to be in different shafts or uneven conditions, it is necessary to adjust. customized CV Joint Retaining Ring manufacturers .05mm.
If you lose adjust the axis gap to make the two rounds parallel, and then adjust the radial gap to make the two wheels concentric. It can greatly improve the speed of the universal coupling. Bitter equipment manufacturers do not have specific requirements. When adjusting the level of the machine pump first, then based on the universal coupling of the machine pump as the benchmial Plug -in clearance and then adjust the shaft.
Generally, the shaft clearance (concentricity) and the facade (parallel) error of the universal tinocculent uranium is not greater than 0. The measurement of the same axis should be performed in the four orientation of the end surface of the universal shaft device and the circular weekly.The different shafts of the universal shaft may be radial displacement, tilt or both.
Cross -shaft -type universal connected machine pumps are inevitably adjusted during the device to adjust the same axis, so that the rotation is both concentric and parallel, otherwise it will affect the use efficiency of the machine pump or cause equipment operation accidents.
When measuring, you can follow the following order: Temporarily connect to each other with half a thousand direction of uranium uranium A and B to set up special tools.Turn the semi -connected axis A and B at the same time, so that the dedicated tools or alignment lines are transferred in turn
dojhousing