Should adjust the bearing axial clearance φ40 to 0. If necessary, grinding or scraping can be used to improve contact. No debris is allowed.08-0.. N100 lubricating oil is installed in the machine base to the specified height. Before assembly, all parts are cleaned with kerosene, and rolling bearings are cleaned with gasoline. Check the split surface, contact surfaces and seals of the reducer, and no oil leakage is allowed.
The inner wall meshing backlash shall be inspected with lead wire not less than 0. Check the spots by painting.Apply paint that is not corroded by engine China Worm Gearboxes Manufacturers oil twice. The split surface is allowed to be coated with sealing paint or water glass, and no filler is allowed. In order to help the customer to install the reducer, the following describes the technical requirements for the reducer installation.16mm, and the lead wire shall not be greater than 4 times the minimum backlash.15mm.
The contact point according to the tooth height is not less than 40%; the contact spot according to the tooth length is not less than 50%. In summary, we see the technical requirements for the installation of the reducer. If the torque is calculated, the speed can meet the normal operation, but when the servo is fully output, when there is insufficient phenomenon, we can do it in the driver on the motor side. Current limiting control, or torsion protection on the mechanical shaft, it is necessary.
The applicability of the reducer is very high, and the working coefficient can be maintained above 1.In order to help customers choose the ideal reducer, the next step is to analyze how to choose the ideal reducer.
The applicable power is usually the applicable power of the servo models on the market.. The output shaft diameter of the selected servo motor should not be greater than the maximum use shaft diameter in the table. Try to choose close to the ideal reduction ratio,reduction ratio = servo motor speed / reducer output shaft speed; for the life of the reducer, torque calculation is very important, and pay attention to the maximum torque value (TP) of acceleration, whether it exceeds the reducer The maximum load torque.2, but the selection can also be determined by your own needs
heavyload