In general, LED lamps are not easily damaged and energy-saving and environmentally friendly. The main reason is that the filter capacitor fault 1. LED light and LED driver power supply do not match, normal single-legged 1 W lamp, current at: 280-300 mA, voltage: If there is an overwenity protection function, the material heat dissipation performance cannot be required, and there will be a phenomenon of flashing, such as: 20W shouting, the shell is used to assemble 30W.
4V voltage.0-3. 2.4 V, if the power of the bead chip can cause light source Frequent flashing phenomenon, the light-beads of large currents cannot withstand bright, severe phenomenon, will burn the bulk lines or copper wire built into the lamp beads, resulting in the light of the lights. , Zero line power. Lamps, cooling work is not working hard. Note: LED beads do not match the LED drive power.
The lamp beads and drivers are broken, and if they drive the waterproof, it is just bad of the lamp, and the LED track Light Zhongshan supplier recommends replacing the light source. 3. Ordinary 1W magnetic beads can withstand the current of 280-300mA and 3. If there is no problem, the LED light may be generating self-inductive current. .
0-3. Z simple method is to purchase a 220V relay, coil and lamp string, can be resolved. If the outdoor luminaire is also flashing, it is bright, that is, the lamp is in Die Casting Empty Led Street Light Housing water. LED flashing solution: The lamp is turned off, first confirming the wiring problem, the z Possible problem is the switch-controlled zero line.
The consequence is that it is flashed and it is not bright. It may be that the drive power is broken, and the LED track light is not flashing with another good drive power supply. 4. If the magnetic bead chip does not have enough power, it will generate a flash. This time should be corrected in time to avoid danger, the correct method is the switch control of the fire
lightingstreet