The axial gap between the adjustment of the bearing axial gap can be achieved by means of the axial position of the moving outer ring.During the measurement process, the ball should be guaranteed to fall into the ditch, and the closed bearing measured before closing.5 mm, the bearing is required to operate the gap, then the adjustment bolt requires a rotation angle of 3600 × 0. This early injury is relative to fatigue life, which is called the quality limit of the failure or accident.
Therefore, to configure the appropriate shelves, and the bottom layer of the shelf should be higher than the ground 30cm. After the coating, dust removal is covered with a plastic film.Whether the installation of bearing installation bearing is correct, affecting accuracy, life, performance. The criteria that the judgment varies depending on the mechanical properties and importance and inspection cycle.
The axial gap required to be; this is the total thickness of the desired fill the gasket, and then fill the ready space between the bearing end cover and the bearing seat end surface, and finally tighten the screws. For example, the pitch is 1. At this time, if the bearing is rotated in the oil, it is noted that the scroll surface is damaged due to foreign matter.
The variety of lubricants can be used in non-standard bearings factory Japan’s central oil-resistant (COC) to high temperature grease bearing oil, which can be determined according to product varieties, condition conditions and viscosity levels. Reserved bearings.
The bearing material rolled the ferrule and the rolling body, one side to withstand high contact pressure, and perform rolling contact with sliding. However, there will be unexpectedly damage to the situation where it is resistant to use. Bearing damage and countermeasure bearing injury typically uses the bearing correctly, can be used to achieve fatigue life.
skfkits