Imagen de avatar Wholesale Clutch Release Bearing
skfkits

The polymer polymer is also known as organic polymer materials

Under atmospheric and room temperature conditions, the friction factor and wear rate of chrome plating surface are very low. The thick-walled shaft is made of casting method, and the inner surface can be attached to the inner surface of the centrifugal crankshaft, which can often be attached to the inner surface of cast iron, steel or bronze shaft.

The polymer has the characteristics of light, insulating, anti-migration, wear resistance, self-lubrication, corrosion resistance, and high production efficiency. The circumferential oil tank is suitable for situations where the weight range exceeds 180 °, which is often located in the middle of the bearing width, divides the bearing into two independent portions; when the width is the same, the carrying capacity of the circumferential oil tank bearing is lower than the shaft Bearing of the oil tank.

The microstructure is determined by raw materials, composition, and manufacturing processes. The sliding bearing is damaged after the flask. Its moisturism and deterioration depend on the amount of water that adsorbed, but lubricity will be lost when humidity is low. In order to introduce the lubricant into the entire friction,Mechanical ball bearings Factory the oil hole or oil tank must be opened on the shaft tile or the journal.

The non-lubricating bearing capacity of the plastic (such as PTFE) is better, the embedded, defensiveness and wear resistance are better. Carbon – graphite can also make water lubricated shaft material. The shave wattling tile tabs of the shaft tiles are direct support shafts. Thick wall shafts and thin-walled watts of the open bearing.

The polymer polymer is also known as organic polymer materials, engineering plastics. If the contact surface of the shaft and the shaft tile is to ensure that the oil film is destroyed in a few small or a piece of area, the friction generated by the pressure being affected by the pressure is much larger than the place where the contact is even

Tags:

Deja un comentario