Remove the two licenseplate bolts and insert them through the camera bolt holes and back onto thecar. Identify thecar wires that offer power to the reversing lights. Seal withelectrical tape. Auto Aftermarket car cameras mostly are wireless, so there is noneed many connection to make between the view monitor which places on the dashand the car camera which installs at the rear license plate.Process 4Trim and strip 1/4 inch of plasticsheathing off the end of the wire at the reversing light housing. Insert thepower supply from the view monitor into the cigarette lighter plug on the car’sdashboard. Use the license plate light hole to put the wiring through to the trunk.Process 5Attach the display monitor to a convenientposition on the dashboard. But, the cameraneeds power, as does the monitor.
The license plate light can supply a convenient hole, or simplydrill a new hole and Gas spring monitor bracket weatherize it with a grommet. Identify them by tracingthe wiring back from the reversing light bulb connector.Process 2Install the camera. This should be at a convenient, easy toreach location–the middle is fine.Process 3Run the red and white cable from the car camerayou have installed on the license plate frame to a reversing light housinginside the car. Use the contained hook and loop tape. Test and then replace the plastic or carpet panel. Strip 1/4- inch ofplastic sheathing and off the wire. Wrap the car camera wires around thereversing light wires, match red wire to red and black wire to black.You’ll Need Car upholstery removal tool, Drilland bit, Wire strippers, Grommet and Electrical tape.
The view monitor display on the dashboard uses power from thecigarette lighter plug.As we know insert the power supply for the carcamera display monitor into the cigarette lighter should plug on the car’sdashboard.net. If yourcar is an SUV or something similar, expose the innards inside the tailgate. The car’s reversing lights supplies aconveniently placed power source for the camera that switches the camera ononly when needed.Process1Remove the plastic or carpet panel on theinside of the trunk behind the license plate and below the trunk lid.carcameras.Fortunately, we are the professional of carcamera.
DE