At this time, the agitator will enter an adjustable intermittent rotation. The thermal insulation layer is filled with rigid foam plastic with small thermal conductivity, so it is light in weight and has good thermal insulation performance. The direct cooling milk tank is mainly composed of four parts: milk tank body, automatic mixer, refrigeration unit and microcomputer control box. When the equipment arrives, check the box for damage before unpacking, verify the box number and quantity, and take care not to damage the parts when unpacking.
Refrigerant has been added to the equipment at the factory, so the valve should not be opened at will during transportation and storage. The compressor has high-pressure pressure fault protection and motor overload protection (high-pressure protection value is 2. At the same time, consider the transportation route and the door size of the machine room. You must check at this time After troubleshooting, you can press the reset button to continue working.
The stirring motor and the compressor work synchronously. The direct cooling milk storage tank adopts fully automatic control, and the electric control box can be installed on the side or near end of the milk tank for easy automatic control.0MPa, low-pressure shutdown value is 0. When the milk tank needs to be pre-cooled, it can be turned on manually. Pay attention to damage during transportation, and lift and handle gently. When the compressor stops working, if necessary, the stirring switch can be set to automatic gear. Housing location requirements: The total area of the milk tank machine room is not less than 40 square meters, and the air circulation in the machine room must be maintained.
The milk tank equipment is combined with the electrical control box to automatically control the temperature of the refrigeration system.2MPa). The location of the milk tank in the machine room must ensure that the milk tank pipe box is 1m away from the refrigeration unit. The handling of direct cooling milk tank equipment also requires a lot of attention. The milk tank body is all made of stainless steel, corrosion-resistant, and precision polished to prevent dirt from accumulating. Milk tanks and refrigeration units are generally packaged in separate parts.The direct cooling milk tank is suitable for storing and cooling fresh milk or goat milk that has just been squeezed out in the pasture.
It can also be used in small milk collection stations, dairy processing plants and food, feed, medicine, and factory storage and cooling of liquid materials. According to the packing list, count all the pieces and check whether the equipment is damaged.. Main technical parameters: stainless steel beer tank factory Rated capacity 2000L 3000L 4000L 5000L Average cooling capacity 14KW working fluid, R22 injection volume, 10-12Kg stirrer speed, 30-35r/min supporting total power, 5.52KW 77 power supply, 3-380V-50HZ. In case of the above-mentioned faults, the circuit will be automatically disconnected, an alarm will be issued, and the compressor will stop working
homebrewhouse